PurposeCommand or Action
Displays the call-home diagnostic signature
information.
show call-home diagnostic-signature [ds-id [actions | events
| prerequisite | prompt | variables] | failure | statistics
[download]]
Step 9
Example:
Router# show call-home diagnostic-signature actions
Verifying the Call Home Configuration
• show call-home —Displays the Call Home configuration summary.
Following is a sample output of the command:
Router# show call-home
Current call home settings:
call home feature : enable
call home message's from address: Not yet set up
call home message's reply-to address: Not yet set up
vrf for call-home messages: Not yet set up
contact person's email address: sch-smart-licensing@cisco.com (default)
contact person's phone number: Not yet set up
street address: Not yet set up
customer ID: Not yet set up
contract ID: Not yet set up
site ID: Not yet set up
source ip address: Not yet set up
source interface: TenGigabitEthernet4/1/1
Mail-server[1]: Address: 173.36.13.143 Priority: 60
http proxy: Not yet set up
Diagnostic signature: enabled
Profile: CiscoTAC-1 (status: ACTIVE)
Smart licensing messages: enabled
Profile: CiscoTAC-1 (status: ACTIVE)
aaa-authorization: disable
aaa-authorization username: callhome (default)
data-privacy: normal
syslog throttling: enable
Rate-limit: 20 message(s) per minute
Snapshot command[0]: show cable modem summary totalb
Snapshot command[1]: show cable modem summary total
Available alert groups:
Keyword State Description
------------------------ ------- -------------------------------
configuration Enable configuration info
crash Enable crash and traceback info
diagnostic Enable diagnostic info
environment Enable environmental info
inventory Enable inventory info
snapshot Enable snapshot info
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
for Cisco IOS XE Fuji 16.8.x
37
Call Home
Verifying the Call Home Configuration
To Next Page
Loading...
Need help?
General
