CHAPTER 10
Maximum CPE and Host Parameters
This document describes how to use different methods to control subscriber access that are allowed by the
Data-over-Cable Service Interface Specifications (DOCSIS) for use on cable networks.
•
Finding Feature Information, page 217
•
Hardware Compatibility Matrix for the Cisco cBR Series Routers, page 218
•
Information About the MAX CPE and Host Parameters, page 218
•
How to Configure the MAX CPE and Host Parameters, page 222
•
Configuration Examples, page 224
•
Additional References, page 225
•
Feature Information for Maximum CPE and Host Parameters, page 226
Finding Feature Information
Finding Feature Information
Your software release may not support all the features that are documented in this module. For the latest
feature information and caveats, see the release notes for your platform and software release. The Feature
Information Table at the end of this document provides information about the documented features and lists
the releases in which each feature is supported.
Use Cisco Feature Navigator to find information about the platform support and Cisco software image support.
To access Cisco Feature Navigator, go to the link http://tools.cisco.com/ITDIT/CFN/. You do not require a
cisco.com login account.
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
for Cisco IOS XE Fuji 16.8.x
217
To Next Page
Loading...
