Cisco cBR 8 - Disabling the Usage-Based Billing Feature

ciscoFlashMiscOpStatus
.31
ciscoFlashCopyStatus.582 = miscOpOperationSuccess(2)
workstation# setany -v2c 10.8.8.21 rw-string
ciscoFlashMiscOpEntryStatus
.32 -i 5
workstation# setany -v2c 10.8.8.21 rw-string
ciscoFlashMiscOpCommand
.32 -i 5
workstation# setany -v2c 10.8.8.21 rw-string
ciscoFlashMiscOpDestinationName
.32 -D slot0:
workstation# setany -v2c 10.8.8.21 rw-string
ciscoFlashMiscOpEntryStatus
.32 -i 1
workstation#
Disabling the Usage-based Billing Feature
This section describes how to disable the Usage-based Billing. Giving this command immediately stops the
collection of billing information. If a billing record is currently written or being streamed to an external server,
the CMTS completes the operation before disabling the usage-based billing feature.
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password
if prompted.
enable
Example:
Router> enable
Step 1
Example:
Router#
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Example:
Router(config)#
Immediately disables the Usage-based Billing feature
and stops the collection of billing information.
no cable metering
Example:
Router(config)# no cable metering
Step 3
Example:
Router(config)#
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration
Guide for Cisco IOS XE Fuji 16.8.x
176
Usage-Based Billing (SAMIS)
Disabling the Usage-based Billing Feature