Example:
!Verify the connectivity to TenGigabitEthernet4/1/1 interface
Router# ping vrf smart-vrf 172.22.11.25
!Verify the connectivity to TenGigabitEthernet4//1/1 gateway
Router# ping vrf smart-vrf 172.22.11.1
!Verify the connectivity to tools.cisco.com
Router# ping vrf smart-vrf 72.163.4.38
Step 7
Configure the HTTP client interface.
Example:
Router(config)# ip http client source-interface TenGigabitEthernet4/1/1
Step 8
Send the Call Home alert group message manually and verify the configuration.
Example:
Router# call-home send alert inventory profile CiscoTAC-1
Sending inventory info call-home message ...
Please wait. This may take some time ...
Router# show call-home statistics | include Total
Message Types Total Email HTTP
Total Success 0 0 0
Total In-Queue 1 0 1
Total Failed 0 0 0
Total Ratelimit
Router# show call-home statistics | include Total
Message Types Total Email HTTP
Total Success 1 0 1
Total In-Queue 0 0 0
Total Failed 0 0 0
Total Ratelimit
Step 9
Display the Call Home configuration.
Example:
Router# show call-home profile CiscoTAC-1
Profile Name: CiscoTAC-1
Profile status: ACTIVE
Profile mode: Full Reporting
Reporting Data: Smart Call Home, Smart Licensing
Preferred Message Format: xml
Message Size Limit: 3145728 Bytes
Transport Method: http
Email address(es): callhome@cisco.com
HTTP address(es): https://tools.cisco.com/its/service/oddce/services/DDCEService
Periodic configuration info message is scheduled every 15 day of the month at 15:37
Periodic inventory info message is scheduled every 15 day of the month at 15:22
Alert-group Severity
------------------------ ------------
crash debug
diagnostic minor
environment minor
inventory normal
Syslog-Pattern Severity
------------------------ ------------
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
for Cisco IOS XE Fuji 16.8.x
43
Call Home
Example: Configuring HTTP Transport for Call Home on the Cisco cBR Series Router
To Next Page
Loading...
Need help?
General
