Cisco cBR 8 - Hardware Compatibility Matrix for the Cisco Cbr Series Routers; Information about the MAX CPE and Host Parameters

Hardware Compatibility Matrix for the Cisco cBR Series Routers
The hardware components that are introduced in a given Cisco IOS-XE Release are supported in all
subsequent releases unless otherwise specified.
Note
Table 36: Hardware Compatibility Matrix for the Cisco cBR Series Routers
Interface CardsProcessor EngineCisco CMTS Platform
Cisco IOS-XE Release 16.5.1 and
Later Releases
Cisco cBR-8 CCAP Line Cards:
• PID—CBR-LC-8D30-16U30
• PID—CBR-LC-8D31-16U30
• PID—CBR-RF-PIC
• PID—CBR-RF-PROT-PIC
• PID—CBR-CCAP-LC-40G-R
Cisco cBR-8 Downstream PHY
Modules:
• PID—CBR-D30-DS-MOD
• PID—CBR-D31-DS-MOD
Cisco cBR-8 Upstream PHY
Modules:
• PID—CBR-D30-US-MOD
• PID—CBR-D31-US-MOD
Cisco IOS-XE Release 16.5.1 and
Later Releases
Cisco cBR-8 Supervisor:
• PID—CBR-SUP-250G
• PID—CBR-CCAP-SUP-160G
• PID—CBR-CCAP-SUP-60G
• PID—CBR-SUP-8X10G-PIC
Cisco cBR-8 Converged
Broadband Router
Information About the MAX CPE and Host Parameters
The DOCSIS specification includes a number of provisions to allow service providers to control the number
of subscribers who can access the network through any particular cable modem.
The following are the parameters that controls the number of CPE that can access the network:
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration
Guide for Cisco IOS XE Fuji 16.8.x
218
Maximum CPE and Host Parameters
Hardware Compatibility Matrix for the Cisco cBR Series Routers