Cisco cBR 8 - Sending Call Home Messages Manually; Sending a Call Home Test Message Manually; Sending Call Home Alert Group Messages Manually

PurposeCommand or Action
Example:
Device(cfg-call-home)# data-privacy
level high
Enabling the data-privacy command can affect CPU utilization
when scrubbing a large amount of data.
Note
• normal—Scrubs sensitive data such as passwords.
• high—Scrubs all normal-level commands plus the IP domain name
and IP address commands.
• hostname—Scrubs all high-level commands plus the hostname
command.
Scrubbing the hostname from configuration messages can cause
Smart Call Home processing failure on some platforms.
Note
Sending Call Home Messages Manually
Sending a Call Home Test Message Manually
You can use the call-home test command to send a user-defined Call Home test message.
SUMMARY STEPS
1.
call-home test [“test-message”] profile name
DETAILED STEPS
PurposeCommand or Action
Sends a test message to the specified destination profile. The
user-defined test message text is optional, but must be enclosed in quotes
call-home test [“test-message”] profile name
Example:
Router# call-home test profile profile1
Step 1
(“ ”) if it contains spaces. If no user-defined message is configured, a
default message is sent.
Sending Call Home Alert Group Messages Manually
Before You Begin
•
Only the snapshot, crash, configuration, and inventory alert groups can be sent manually. Syslog alert
groups cannot be sent manually.
•
When you manually trigger a snapshot, configuration, or inventory alert group message and you specify
a destination profile name, a message is sent to the destination profile regardless of the profile's active
status, subscription status, or severity setting.
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
for Cisco IOS XE Fuji 16.8.x
25
Call Home
Configuring Call Home