Cisco cBR 8 - Page 173

DescriptionTypeObject
• false—Information
for
each
cable
modem
is
not
aggregated
into
a
single
billing
record,
but
instead
each
service
flow
is
recorded
into
its
own
record
(default).
(Optional)
Specifies
the
source-interface
for
the
billing
packets.
TruthValueccmtrCollectionSrcIfIndex
The following steps use the standard SNMP commands that are available on many Unix and Linux systems.
For each step, replace ip-address with the IP address of the Cisco CMTS, and replace rw-community-string
with an SNMP community string that provides read-write access to the router.
Note
Step 1
Set the ccmCollectionType object to 3, to enable the Usage-based Billing feature and to configure it for streaming mode:
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
for Cisco IOS XE Fuji 16.8.x
161
Usage-Based Billing (SAMIS)
Enabling Usage-based Billing Feature Streaming Mode Using SNMP Commands