Cisco cBR 8 - Page 184

Example:
workstation# setany -v2c ip-address rw-community-string ciscoFlashCopyEntryStatus.582 -i 5
workstation#
Step 3
Set the ciscoFlashCopyCommand to 3 (copyFromFlash) to specify that the billing record file should be copied from the
router’s Flash file system:
Example:
workstation# setany -v2c ip-address rw-community-string ciscoFlashCopyCommand
.582
-i 3
workstatioN#
Step 4
Set the ciscoFlashCopyServerAddress object to the IP address of the TFTP server:
Example:
workstation# setany -v2c ip-address rw-community-string ciscoFlashCopyServerAddress
.582
-a "172.20.12.193"
workstatioN#
Step 5
Set the ciscoFlashCopySourceName object to the file name, including the device name, of the billing record file to be
transferred:
Example:
workstation# setany -v2c ip-address rw-community-string ciscoFlashCopySourceName
.582
-D
"slot0:CMTS01_20030211-155025
"
workstation#
Step 6
(Optional) To specify a specific destination on the TFTP server, set the ciscoFlashCopyDestinationName object to the
path name and file name for the billing record file on the TFTP server. (Typically, the path name and file name should
already exist on the TFTP server.)
Example:
workstation# setany -v2c ip-address rw-community-string ciscoFlashCopyDestinationName
.582
-D
"/cmts01-billing/billing-file
"
workstation#
Step 7
To execute the command, set the ciscoFlashCopyEntryStatus object to the active state (1):
Example:
workstation# setany -v2c ip-address rw-community-string ciscoFlashCopyEntryStatus.582 -i 1
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration
Guide for Cisco IOS XE Fuji 16.8.x
172
Usage-Based Billing (SAMIS)
Retrieving Records from a Cisco CMTS in File Mode