Cisco cBR 8 User Manual

PurposeCommand or Action
Enters cable interface configuration mode for the specified
cable interface.
interface cable x/y
Example:
Router(config)# interface cable 4/0
Step 3
Enables automatic power adjustment on an upstream port
for this cable interface.
cable upstream n power-adjust {continue pwr-level |
noise perc-pwr-adj | threshold value}
Step 4
Example:
Router(config-if)# cable upstream 0 power-adjust
Repeat 4 for each upstream port on the cable
interface.
Note
threshold 2
Example:
Router(config-if)# cable upstream 0 power-adjust
noise 50
Specifies the percentage of frequency adjustment packets
needed to change the adjustment method from the regular
cable upstream n freq-adj averaging percent
Example:
Router(config-if)# cable upstream 0 freq-adj
Step 5
power-adjustment method to the automatic power
adjustment method.
averaging 50
Exits interface configuration mode.exit
Example:
Router(config-if)# exit
Step 6
Exits global configuration mode.exit
Example:
Router(config)# exit
Step 7
What to Do Next
The default settings are adequate for system operation. Amplitude averaging is an automatic procedure.
In general, Cisco does not recommend that you adjust values. Cisco does recommend, however, that you
clean up your cable plant should you encounter flapping cable modems.
Caution
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
for Cisco IOS XE Fuji 16.8.x
203
Flap List Troubleshooting
Enabling or Disabling Power Adjustment Using the CLI (optional)

Cisco cBR 8 Specifications

General

Brand	Cisco
Model	cBR 8
Category	Network Router
Language	English