Cisco cBR 8 User Manual

6 uschan 0 0 0.0 0.0 0
7 serv flow 0 0 0.0 0.0 0
7 sflog 0 0 0.0 0.0 0
7 cm 0 0 0.0 0.0 0
7 cmtx 0 0 0.0 0.0 0
7 paramset 0 0 0.0 0.0 0
7 DXIF 0 0 0.0 0.0 0
7 sid 0 0 0.0 0.0 0
7 uschan 0 0 0.0 0.0 0
8 serv flow 0 0 0.0 0.0 0
8 sflog 0 0 0.0 0.0 0
8 cm 0 0 0.0 0.0 0
8 cmtx 0 0 0.0 0.0 0
8 paramset 0 0 0.0 0.0 0
8 DXIF 0 0 0.0 0.0 0
8 sid 0 0 0.0 0.0 0
8 uschan 0 0 0.0 0.0 0
9 serv flow 0 0 0.0 0.0 0
9 sflog 0 0 0.0 0.0 0
9 cm 0 0 0.0 0.0 0
9 cmtx 0 0 0.0 0.0 0
9 paramset 0 0 0.0 0.0 0
9 DXIF 0 0 0.0 0.0 0
9 sid 0 0 0.0 0.0 0
9 uschan 0 0 0.0 0.0 0
•
To display all the SNMP background sync data on Supervisor side or line card side, use the show cable
bgsync sync-info cable command as shown in the example below:
Router#show cable bgsync sync-info cable 9/0/1
part1 for srv template:
srv_tmp_id min_rate max_rate max_burst
0 0 0 0
1 0 64000 0
2 0 1000000 0
3 0 1000000 3044
4 0 0 3044
5 0 110000000 30000
6 0 0 3044
7 0 2000000000 5000000
8 0 0 3044
part2 for srv flow:
sfid prov_qos adm_qos act_qos wb_mode octets pkts delay_pkts
drop_pkts gate_id create_time total_active_time
1 0 0 0 0 0 0 0
0 0 0 0
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
for Cisco IOS XE Fuji 16.8.x
231
SNMP Background Synchronization
Verifying SNMP Background Synchronization

Cisco cBR 8 Specifications

General

Brand	Cisco
Model	cBR 8
Category	Network Router
Language	English