Cisco IE 3000 User Manual

Contents
xi
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
Configuring NAC Layer 2 IEEE 802.1x Validation 10-38
Configuring Web Authentication 10-38
Disabling IEEE 802.1x Authentication on the Port 10-41
Resetting the IEEE 802.1x Authentication Configuration to the Default Values 10-42
Displaying IEEE 802.1x Statistics and Status 10-42
CHAPTER 11 Configuring Interface Characteristics 11-1
Understanding Interface Types 11-1
Port-Based VLANs 11-2
Switch Ports 11-2
Access Ports 11-2
Trunk Ports 11-3
EtherChannel Port Groups 11-3
Dual-Purpose Uplink Ports 11-4
Connecting Interfaces 11-4
Using Interface Configuration Mode 11-4
Procedures for Configuring Interfaces 11-6
Configuring a Range of Interfaces 11-6
Configuring and Using Interface Range Macros 11-8
Configuring Ethernet Interfaces 11-10
Default Ethernet Interface Configuration 11-10
Setting the Type of a Dual-Purpose Uplink Port 11-11
Configuring Interface Speed and Duplex Mode 11-13
Speed and Duplex Configuration Guidelines 11-13
Setting the Interface Speed and Duplex Parameters 11-14
Configuring IEEE 802.3x Flow Control 11-15
Configuring Auto-MDIX on an Interface 11-16
Adding a Description for an Interface 11-17
Configuring the System MTU 11-17
Monitoring and Maintaining the Interfaces 11-19
Monitoring Interface Status 11-19
Clearing and Resetting Interfaces and Counters 11-20
Shutting Down and Restarting the Interface 11-20
CHAPTER 12 Configuring Smartports Macros 12-1
Understanding Smartports Macros 12-1
Configuring Smartports Macros 12-2
Default Smartports Macro Configuration 12-2
Smartports Macro Configuration Guidelines 12-3

Cisco IE 3000 Specifications

General

Operating Temperature	-40 to 75°C (-40 to 167°F)
DRAM	128 MB
Flash Memory	32 MB
Uplink Ports	2 x 10/100/1000Base-T or SFP
MAC Address Table Size	8000
Mounting	DIN rail, Wall