Cisco IE 3000 - Page 726

Index
IN-4
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
boot loader
accessing 4-18
described 4-2
environment variables 4-18
prompt 4-18
trap-door mechanism 4-2
BPDU
error-disabled state 18-2
filtering 18-3
RSTP format 17-12
BPDU filtering
described 18-3
disabling 18-12
enabling 18-12
support for 1-6
BPDU guard
described 18-2
disabling 18-12
enabling 18-11
support for 1-6
bridge protocol data unit
See BPDU
broadcast storm-control command 22-4
broadcast storms 22-1
C
cables, monitoring for unidirectional links 25-1
candidate switch
automatic discovery 6-4
defined 6-3
requirements 6-3
See also command switch, cluster standby group, and
member switch
Cisco IE 3000
configuring alarm profiles
attaching an alarm profile to a port 3-11
creating or modifying alarm profiles 3-10
configuring switch alarms 3-1 to 3-12
configuring the FCS bit error rate alarm
setting the FCS error hysteresis threshold 3-9
setting the FCS error threshold 3-8
configuring the power supply alarm
setting the power mode 3-4, 3-5
setting the power supply alarm options 3-5
configuring the temperature alarms
associating the temperature alarms to a relay 3-7
setting a secondary temperature threshold 3-6, 3-7
default alarm configuration 3-4
displaying Catalyst 2955 switch alarms 3-12
enabling SNMP traps 3-11
FCS error hysteresis threshold 3-2
global status monitoring alarms
power supply alarm 3-2
temperature alarm 3-2
port status monitoring alarms
FCS bit error rate alarm 3-3
link fault alarm 3-3
port is not operating alarm 3-3
port not forwarding alarm 3-3
triggering alarm options
configurable relays 3-3
FCS Bit Error Rate alarm 3-3
methods to trigger 3-3
SNMP traps 3-4
syslog messages 3-4
CA trustpoint
configuring 9-40
defined 9-38