Index
IN-6
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
clusters, switch (continued)
planning considerations
automatic discovery 6-4
automatic recovery 6-9
CLI 6-14
host names 6-12
IP addresses 6-12
LRE profiles 6-14
passwords 6-13
RADIUS 6-13
SNMP 6-13, 6-15
TACACS+ 6-13
See also candidate switch, command switch, cluster
standby group, member switch, and standby command
switch
cluster standby group
automatic recovery 6-11
considerations 6-10
defined 6-2
requirements 6-3
virtual IP address 6-10
See also HSRP
CNS 1-4
Configuration Engine
configID, deviceID, hostname 5-3
configuration service 5-2
described 5-1
event service 5-3
embedded agents
described 5-5
enabling automated configuration 5-6
enabling configuration agent 5-9
enabling event agent 5-7
management functions 1-4
command-line interface
See CLI
command modes 2-1
commands
abbreviating 2-4
no and default 2-4
commands, setting privilege levels 9-8
command switch
accessing 6-10
active (AC) 6-9
configuration conflicts 34-7
defined 6-2
passive (PC) 6-9
password privilege levels 6-14
priority 6-9
recovery
from command-switch failure 6-9, 34-4
from lost member connectivity 34-7
redundant 6-9
replacing
with another switch 34-6
with cluster member 34-4
requirements 6-3
standby (SC) 6-9
See also candidate switch, cluster standby group,
member switch, and standby command switch
community strings
configuring 6-13, 29-8
for cluster switches 29-4
in clusters 6-13
overview 29-4
SNMP 6-13
compact flash 1-2, 4-2
compatibility, feature 22-12
config.text 4-16
configurable leave timer, IGMP 21-5
configuration, initial
defaults 1-10
Express Setup 1-2
configuration changes, logging 28-10
configuration conflicts, recovering from lost member
connectivity
34-7
To Next Page
Loading...
