Cisco IE 3000 - Page 748

Index
IN-26
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
Rapid Spanning Tree Protocol
See RSTP
rcommand command 6-14
RCP
configuration files
downloading B-17
overview B-15
preparing the server B-16
uploading B-18
image files
deleting old image B-35
downloading B-33
preparing the server B-32
uploading B-35
readiness check
port-based authentication
configuring 10-22
described 10-9, 10-22
reconfirmation interval, VMPS, changing 13-27
reconfirming dynamic VLAN membership 13-27
recovery procedures 34-1
redundancy
EtherChannel 33-2
STP
backbone 16-8
path cost 13-22
port priority 13-20
redundant links and UplinkFast 18-13
reloading software 4-20
Remote Authentication Dial-In User Service
See RADIUS
Remote Copy Protocol
See RCP
Remote Network Monitoring
See RMON
Remote SPAN
See RSPAN
remote SPAN 26-2
report suppression, IGMP
described 21-6
disabling 21-15
resequencing ACL entries 30-12
resetting a UDLD-shutdown interface 25-6
responder, IP SLAs
described 31-4
enabling 31-6
response time, measuring with IP SLAs 31-4
restricted VLAN
configuring 10-32
described 10-12
using with IEEE 802.1x 10-12
restricting access
NTP services 7-8
overview 9-1
passwords and privilege levels 9-2
RADIUS 9-17
TACACS+ 9-10
retry count, VMPS, changing 13-28
RFC
1112, IP multicast and IGMP 21-2
1157, SNMPv1 29-2
1305, NTP 7-2
1757, RMON 27-2
1901, SNMPv2C 29-2
1902 to 1907, SNMPv2 29-2
2236, IP multicast and IGMP 21-2
2273-2275, SNMPv3 29-2
RMON
default configuration 27-3
displaying status 27-6
enabling alarms and events 27-3
groups supported 27-2
overview 27-1
statistics
collecting group Ethernet 27-5
collecting group history 27-5
support for 1-10