Cisco IE 3000 - Page 750

Index
IN-28
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
secure HTTP server
configuring 9-41
displaying 9-43
secure MAC addresses
deleting 22-16
maximum number of 22-9
types of 22-9
secure ports, configuring 22-8
secure remote connections 9-33
Secure Shell
See SSH
Secure Socket Layer
See SSL
security, port 22-8
security features 1-7
See SCP
sequence numbers in log messages 28-8
server mode, VTP 14-3
service-provider network, MSTP and RSTP 17-1
set-request operation 29-4
setup program
failed command switch replacement 34-6
replacing failed command switch 34-4
severity levels, defining in system messages 28-8
SFPs
monitoring status of 11-19, 34-8
security and identification 34-8
status, displaying 34-8
shaped round robin
See SRR
show access-lists hw-summary command 30-17
show alarm commands 3-6, 3-7, 3-10, 3-11, 3-12
show and more command output, filtering 2-10
show cdp traffic command 24-5
show cluster members command 6-14
show configuration command 11-17
show controllers lre profile mapping 3-7
show forward command 34-15
show interfaces command 11-14, 11-17
show interfaces switchport 19-4
show lldp traffic command 23-7
show platform forward command 34-15
show running-config command
displaying ACLs 30-16, 30-17
interface description in 11-17
shutdown command on interfaces 11-20
Simple Network Management Protocol
See SNMP
small-frame arrival rate, configuring 22-5
Smartports macros
applying Cisco-default macros 12-6
applying global parameter values 12-5, 12-6
applying macros 12-5
applying parameter values 12-5, 12-7
configuration guidelines 12-3
creating 12-4
default configuration 12-2
defined 12-1
displaying 12-8
tracing 12-3
SNAP 24-1
SNMP
accessing MIB variables with 29-4
agent
described 29-3
disabling 29-7
and IP SLAs 31-2
authentication level 29-10
community strings
configuring 29-8
for cluster switches 29-4
overview 29-4
configuration examples 29-16
default configuration 29-6
engine ID 29-7
groups 29-6, 29-9
host 29-6
ifIndex values 29-5