2-81
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
exceed-action
Usage Guidelines You configure exceed actions for packets that conform to the peak information rate but not the committed
information rate (CIR).
The switch also supports simultaneously marking multiple QoS parameters for the same class and
configuring conform-action, exceed-action, and violate-action marking.
Access policy-map class police configuration mode by entering the police policy-map class command.
See the police policy-map class configuration command for more information.
You can use this command to set one or more exceed actions for a traffic class.
You can verify your settings by entering the show policy-map privileged EXEC command.
Examples This example shows how configure multiple actions in a policy map that sets a committed information
rate of 5000000 bits per second (b/s) and a peak rate of 8000000 b/s:
Switch(config)# policy-map map1
Switch(config-pmap)# class class1
Switch(config-pmap-c)# police cir 5000000 pir 8000000
Switch(config-pmap-c-police)# conform-action transmit
Switch(config-pmap-c-police)# exceed-action set-dscp-transmit 24
Switch(config-pmap-c-police)# violate-action drop
Switch(config-pmap-c-police)# end
Related Commands Command Description
class Defines a traffic classification match criteria for the specified
class-map name.
conform-action Defines the action to take on traffic that conforms to the CIR.
police Defines a policer for classified traffic.
policy-map Creates or modifies a policy map that can be attached to multiple
ports to specify a service policy.
show policy-map Displays QoS policy maps.
violate-action Defines the action to take on traffic with a rate greater than the
conform rate plus the exceed burst.
To Next Page
Loading...
Need help?
General
