Cisco ME 3800X User Manual

CHAPTER
2-1
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
2
Cisco ME 3800X and ME 3600X Switch
Cisco IOS Commands
action
To set the action for the VLAN access map entry, use the action command in access-map configuration
mode. To set the action to the default value, which is to forward, use the no form of this command.
action {drop | forward}
no action
Syntax Description
Defaults The default action is to forward packets.
Command Modes Access-map configuration
Command History
Usage Guidelines You enter access-map configuration mode by using the vlan access-map global configuration command.
If the action is drop, you should define the access map, including configuring any access control list
(ACL) names in match clauses, before applying the map to a VLAN, or all packets could be dropped.
In access-map configuration mode, use the match access-map configuration command to define the
match conditions for a VLAN map. Use the action command to set the action that occurs when a packet
matches the conditions.
The drop and forward parameters are not used in the no form of the command.
You can verify your settings by entering the show vlan access-map privileged EXEC command.
drop Drops the packet when the specified conditions are matched.
forward Forwards the packet when the specified conditions are matched.
Release Modification
12.2(52)EY This command was introduced.

Cisco ME 3800X Specifications

General

Brand	Cisco
Model	ME 3800X
Category	Switch
Language	English