B-35
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Appendix B Cisco ME 3800X and ME 3600X Switch Debug Commands
debug udld
debug udld
To enable debugging of the UniDirectional Link Detection (UDLD) feature, use the debug udld
command in privileged EXEC mode. To disable debugging, use the no form of this command.
debug udld {events | packets | registries}
no debug udld {events | packets | registries}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug udld command is the same as the no debug udld command.
For debug udld events, these debugging messages appear:
• General UDLD program logic flow
• State machine state changes
• Program actions for the set and clear ErrDisable state
• Neighbor cache additions and deletions
• Processing of configuration commands
• Processing of link-up and link-down indications
For debug udld packets, these debugging messages appear:
• General packet processing program flow on receipt of an incoming packet
• Indications of the contents of the various pieces of packets received (such as type length versions
[TLVs]) as they are examined by the packet reception code
• Packet transmission attempts and the outcome
For debug udld registries, these categories of debugging messages appear:
• Sub-block creation
• Fiber-port status changes
events Displays debug messages for UDLD process events as they occur.
packets Displays debug messages for the UDLD process as it receives packets from the
packet queue and tries to send them at the request of the UDLD protocol code.
registries Displays debug messages for the UDLD process as it processes registry calls from
the UDLD process-dependent module and other feature modules.
Release Modification
12.2(52)EY This command was introduced.
To Next Page
Loading...
Need help?
General
