-85
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
uni count
uni count
To set the user-network interface (UNI) count for an Ethernet virtual connection (EVC), use the uni
count command in EVC configuration mode. To return to the default setting, use the no form of this
command.
uni count value [multipoint]
no uni count
Syntax Description
Defaults The default UNI count is 2. The default service, if you do not enter a UNI count, is point-to-multipoint.
Command Modes EVC configuration
Command History
Usage Guidelines The UNI count determines the type of service in the EVC.
• If the command is not entered, the UNI count defaults to 2 and the service defaults to point-to-point
service.
• If you manually enter a value of 2, you can leave the service at the default or can configure
point-to-multipoint service by entering the multipoint keyword.
• If you enter a value of 3 or greater, the service is point-to-multipoint.
You should know the correct number of maintenance end points (MEPs) in the domain. If you enter a
UNI count value greater than the actual number of endpoints, the UNI status shows as partially active
even if all endpoints are up. If you enter a UNI count less than the actual number of endpoints, UNI status
shows as active, even if all endpoints are not up.
value Sets the number of UNIs in the EVC. The range is from 2 to 1024. The default is
2.
multipoint (Optional) Selects point-to-multipoint service. This keyword is visible only
when you enter a uni count value of 2.
• If you do not enter a value or if you enter 1 or 2, the service defaults to
point-to-point service. If you enter 2, you can configure point-to-multipoint
service.
• If you enter a uni count value of 3 or greater, the service is
point-to-multipoint.
Release Modification
12.2(52)EY This command was introduced.
To Next Page
Loading...
Need help?
General
