-86
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
uni count
Caution Configuring a UNI count does not prevent you from configuring more endpoints than the configured
count. For example, if you configure a UNI count of five, but you create ten MEPs, any five MEPs in the
domain can go down without the status changing to Partially Active.
Examples This example shows how to a UNI count of two with point-to-multipoint service:
Switch(config)# ethernet evc test1
Switch(config-evc)# uni count 2 multipoint
Related Commands Command Description
ethernet evc evc-id Defines an EVC and enters EVC configuration mode.