2-102
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
ip igmp max-groups
ip igmp max-groups
To set the maximum number of Internet Group Management Protocol (IGMP) groups that a Layer 2
interface can join, or to configure the IGMP throttling action when the maximum number of entries is in
the forwarding table, use the ip igmp max-groups command in interface configuration mode. To set the
maximum back to the default, which is to have no maximum limit, or to return to the default throttling
action, which is to drop the report, use the no form of this command.
ip igmp max-groups {number | action {deny | replace}}
no ip igmp max-groups {number | action}
Syntax Description
Defaults The default maximum number of groups is no limit.
After the switch learns the maximum number of IGMP group entries on an interface, the default
throttling action is to drop the next IGMP report that the interface receives and to not add an entry for
the IGMP group to the interface.
Command Modes Interface configuration
Command History
Usage Guidelines You can use this command only on Layer 2 physical interfaces and on logical EtherChannel interfaces.
You cannot set IGMP maximum groups for routed ports, switch virtual interfaces (SVIs), or ports that
belong to an EtherChannel group.
Follow these guidelines when configuring the IGMP throttling action:
• If you configure the throttling action as deny and set the maximum group limitation, the entries that
were previously in the forwarding table are not removed but are aged out. After these entries are
aged out, when the maximum number of entries is in the forwarding table, the switch drops the next
IGMP report received on the interface.
number The maximum number of IGMP groups that an interface can join. The range is 0 to
4294967294. The default is no limit.
action deny When the maximum number of entries is in the IGMP snooping forwarding table, drops
the next IGMP join report. This is the default action.
action
replace
When the maximum number of entries is in the IGMP snooping forwarding table,
replaces the existing group with the new group for which the ICMP report was received.
Release Modification
12.2(52)EY This command was introduced.
To Next Page
Loading...
Need help?
General
