2-121
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
ip sla reaction-configuration
Defaults IP SLAs proactive threshold monitoring is disabled.
Command Modes Global configuration (config)
Command History
Usage Guidelines You can configure the ip sla reaction-configuration command multiple times to enable proactive
threshold monitoring for multiple elements, such as configuring thresholds for both
destination-to-source packet loss and MOS for the same operation. However, disabling individual
monitored elements is not supported. The no ip sla reaction-configuration command disables all
proactive threshold monitoring configuration for the specified IP SLAs operation.
The keyword options for this command are not case sensitive. The keywords in online help for the
action-typeoption and react monitored-element keyword and argument combinations contain uppercase
letters to enhance readability only.
The never keyword option for the threshold-type keyword does not work with the unavailableDS and
unavailableSD monitored elements for measuring Ethernet Frame Loss Ratio (FLR).
Not all elements can be monitored by all IP SLAs operations. If you attempt to configure an unsupported
monitored-element, such as MOS for a UDP echo operation, the following message displays:
Invalid react option for the Probe type configured
Examples The following example shows how to configure IP SLAs operation 1:
Switch(config)# ip sla reaction-configuration 1 react loss-ratioSD threshold-type
immediate threshold-value 55 50
Related Commands
threshold-type
never
(Optional) Do not calculate threshold violations. This is the default threshold type.
threshold-value
upper-threshold
lower-threshold
Optional) Specifies the upper-threshold and lower-threshold values of the
applicable monitored elements. See the Default Threshold Values for Monitored
Elements table in the "Usage Guidelines" section for a list of the default values.
Release Modification
15.2(4)S1 This command was introduced.
Command Description
To Next Page
Loading...
Need help?
General
