Cisco Nexus 5000 Series - Shutdown (Virtual Ethernet Interface)

shutdown (virtual Ethernet interface)
To shut down the local traffic on a virtual Ethernet interface, use the shutdown command. To return a virtual
Ethernet interface to its default operational state, use the no form of this command.
shutdown
no shutdown
Syntax Description
This command has no arguments or keywords.
Command Default
Not shut down
Command Modes
Virtual Ethernet interface configuration mode
Command History
ModificationRelease
This command was introduced.5.1(3)N1(1)
Examples
This example shows how to shut down, or disable, a virtual Ethernet interface:
switch#
configure terminal
switch(config)# interface vethernet 10
switch(config-if)# shutdown
switch(config-if)#
Related Commands
DescriptionCommand
Displays the virtual Ethernet interface configuration
information.
show interface vethernet
Cisco Nexus 5000 Series Interfaces Command Reference
90
S Commands
shutdown (virtual Ethernet interface)