Cisco Nexus 5000 Series - Lacp System-Priority

lacp system-priority
To set the system priority of the switch for the Link Aggregation Control Protocol (LACP), use the lacp
system-priority command. To return the system priority to the default value, use the no form of this command.
lacp system-priority priority
no lacp system-priority
Syntax Description
Priority for the physical interfaces. The range of valid
numbers is from 1 to 65535 .
priority
Command Default
System priority value is 32768.
Command Modes
Global configuration mode
Command History
ModificationRelease
This command was introduced.4.0(0)N1(1a)
Usage Guidelines
Each device that runs LACP has an LACP system priority value. You can configure a value between 1 and
65535. LACP uses the system priority with the MAC address to form the system ID and also during negotiation
with other systems.
When setting the priority, note that a higher number means a lower priority.
Examples
This example shows how to set the LACP system priority for the device to 2500:
switch(config)# lacp system-priority 2500
Related Commands
DescriptionCommand
Displays LACP information.show lacp
Cisco Nexus 5000 Series Interfaces Command Reference
66
L Commands
lacp system-priority