Cisco Nexus 5000 Series - Interface Ethernet (Layer 3)

interface ethernet (Layer 3)
To configure a Layer 3 Ethernet IEEE 802.3 routed interface, use the interface ethernet command.
interface ethernet [chassis_ID /] slot / port [.subintf-port-no]
Syntax Description
(Optional) Specifies the Fabric Extender chassis ID.
The chassis ID is from 100 to 199.
This argument is not optional when
addressing the host interfaces of a Cisco
Nexus 2000 Series Fabric Extender.
Note
chassis_ID
Slot from 1 to 3. The following list defines the slots
available:
•
Slot 1 includes all the fixed ports. A Fabric
Extender only has one slot.
•
Slot 2 includes the ports on the upper expansion
module (if populated).
•
Slot 3 includes the ports on the lower expansion
module (if populated).
slot
Port number within a particular slot. The port number
is from 1 to 128.
port
(Optional) Specifies the subinterface separator..
(Optional) Port number for the subinterface. The
range is from 1 to 48.
subintf-port-no
Command Default
None
Command Modes
Global configuration modeInterface configuration mode
Command History
ModificationRelease
This command was introduced.5.0(3)N1(1)
Cisco Nexus 5000 Series Interfaces Command Reference
46
I Commands
interface ethernet (Layer 3)