Cisco Nexus 5000 Series - Show Cdp Entry

show cdp entry
To display the interfaces in the Cisco Discovery Protocol (CDP) database, use the show cdp entry command.
show cdp entry {all| name device-name}
Syntax Description
Displays all interfaces in the CDP database.all
Displays a specific CDP entry matching a name. The
device name can be a maximum of 256 alphanumeric
characters.
name device-name
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.5.0(3)N2(1)
Examples
This example shows how to display all the entries in the CDP database:
switch# show cdp entry all
----------------------------------------
Device ID:savbu-qa-dist-120
System Name:
Interface address(es):
IPv4 Address: 192.168.0.82
Platform: cisco WS-C3750E-24TD, Capabilities: Switch IGMP Filtering
Interface: mgmt0, Port ID (outgoing port): GigabitEthernet1/0/13
Holdtime: 179 sec
Version:
Cisco IOS Software, C3750E Software (C3750E-UNIVERSAL-M), Version 12.2(35)SE5, RELEASE
SOFTWARE (fc1)
Copyright (c) 1986-2007 by Cisco Systems, Inc.
Compiled Thu 19-Jul-07 16:17 by nachen
Advertisement Version: 2
Native VLAN: 16
VTP Management Domain:
Duplex: full
Mgmt address(es):
IPv4 Address: 192.168.0.82
----------------------------------------
Device ID:swor96(SSI13110AAQ)
System Name:swor96
Interface address(es):
IPv4 Address: 192.168.0.1
Platform: N5K-C5010P-BF, Capabilities: Switch IGMP Filtering Supports-STP-Dispute
Interface: Ethernet1/17, Port ID (outgoing port): Ethernet1/19
Cisco Nexus 5000 Series Interfaces Command Reference
97
Show Commands
show cdp entry