load-interval
To change the sampling interval for statistics collections on interfaces, use the load-interval command. To
return to the default sampling interval, use the no form of this command.
load-interval [counter {1| 2| 3}] seconds
no load-interval [counter {1| 2| 3}] [ seconds ]
Syntax Description
Specifies the number of counters configured on the
interface.
1 | 2 | 3
Specifies the interval between sampling statistics on
the interface. The range is from 60 to 300 seconds for
VLAN network interfaces, and the range is from 30
to 300 seconds for Ethernet and port-channel
interfaces.
seconds
Command Default
1—30 seconds; 60 seconds for VLAN network interface
2—300 seconds
3—not configured
Command Modes
Interface configuration mode
network-adminvdc-admin
Command History
ModificationRelease
This command was introduced.5.1(3)N1(1)
Usage Guidelines
Use the load-interval command to obtain bit-rate and packet-rate statistics for three different durations.
You can set the statistics collection intervals on the following types of interfaces:
•
Ethernet interfaces
•
Port-channel interfaces
•
VLAN network interfaces
You cannot use this command on the management interface or subinterfaces.
This command sets the sampling interval for such statistics as packet rate and bit rate on the specified interface.
Cisco Nexus 5000 Series Interfaces Command Reference
69
L Commands
load-interval
To Next Page
Loading...
