Cisco Nexus 5000 Series - Show Lacp

show lacp
To display Link Aggregation Control Protocol (LACP) information, use the show lacp command.
show lacp {counters| interface ethernet slot / port| neighbor [interface port-channel number]| port-channel
[interface port-channel number]| system-identifier}
Syntax Description
Displays information about the LACP traffic statistics.counters
Displays LACP information for a specific Ethernet
interface. The slot number is from 1 to 255, and the
port number is from 1 to 128.
interface ethernet slot /port
Displays information about the LACP neighbor.neighbor
Displays information about all EtherChannels.port-channel
(Optional) Displays information about a specific
EtherChannel. The EtherChannel number is from 1
to 4096.
interface port-channel number
Displays the LACP system identification. It is a
combination of the port priority and the MAC address
of the device.
system-identifier
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.4.0(0)N1(1a)
Usage Guidelines
Use the show lacp command to troubleshoot problems related to LACP in a network.
Examples
This example shows how to display the LACP system identification:
switch# show lacp system-identifier
32768,0-5-9b-78-6e-7c
switch#
Cisco Nexus 5000 Series Interfaces Command Reference
141
Show Commands
show lacp