Cisco Nexus 5000 Series - Show Running-Config Interface

show running-config interface
To display the running configuration for a specific port channel, use the show running-config interface
command.
show running-config interface [ethernet slot / port| fc slot / port| loopback number| mgmt 0| port-channel
channel-number [membership]| vethernet veth-id| vlan vlan-id] [all| expand-port-profile]
Syntax Description
(Optional) Displays the Ethernet interface slot number
and port number. The slot number is from 1 to 255
and the port number is from 1 to 128.
ethernet slot/port
(Optional) Displays the configuration information of
the Fibre Channel interface. The slot number is from
1 to 2 and the port number is from 1 to 48.
fc slot /port
(Optional) Displays the number of the loopback
interface. The range of values is from 1 to 4096.
loopback number
(Optional) Displays the configuration information of
the management interface.
mgmt 0
(Optional) Displays the number of the port-channel
group. The range of values is from 0 to 1023.
port-channel channel-number
Displays the membership of the specified port
channel.
membership
Displays the number of the tunnel interface. The range
of values is from 0 to 65535.
tunnel number
(Optional) Displays the configuration information of
the virtual Ethernet interface. The range is from 1 to
1048575.
vethernet veth-id
(Optional) Displays the configuration information of
the VLAN. The range of values is from 1 to 4096.
vlan vlan-id
(Optional) Displays configured and default
information .
all
(Optional) Displays the configuration information of
port profiles.
expand-port-profile
Command Default
None
Cisco Nexus 5000 Series Interfaces Command Reference
164
Show Commands
show running-config interface