Cisco Nexus 5000 Series - Show Interface Port-Channel

show interface port-channel
To display the information about an EtherChannel interface configuration, use the show interface port-channel
command.
show interface port-channel number [. subinterface-number] [brief| counters| description| status]
Syntax Description
EtherChannel number. The range is from 1 to 4096.
number
(Optional) Port-channel subinterface configuration.
Use the EtherChannel number followed by a dot (.)
indicator and the subinterface number. The format is:
portchannel-number.subinterface-number
.subinterface-number
(Optional) Displays information about the counters
configured on the EtherChannel interface.
counters
(Optional) Displays the description of the
EtherChannel interface configuration.
description
(Optional) Displays the operational state of the
EtherChannel interface.
status
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.4.0(0)N1(1a)
Support for Layer 3 interfaces and subinterfaces was added.5.0(3)N1(1)
Examples
This example shows how to display the configuration information of a specified EtherChannel interface:
switch# show interface port-channel 21
port-channel21 is up
Hardware: Port-Channel, address: 000d.ece7.df72 (bia 000d.ece7.df72)
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
Port mode is trunk
Cisco Nexus 5000 Series Interfaces Command Reference
128
Show Commands
show interface port-channel