Cisco Nexus 5000 Series - Resync-Database

resync-database
To resynchronize the switch profile databases, use the resync-database command.
resync-database
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Switch profile configuration mode
Command History
ModificationRelease
This command was introduced.5.0(2)N2(1)
Examples
This example shows how to resynchronize the switch profile databases:
switch# configure sync
Enter configuration commands, one per line. End with CNTL/Z.
switch(config-sync)# resync-database
Re-synchronization of switch-profile db takes a few minutes...
Re-synchronize switch-profile db completed successfully.
switch(config-sync)#
Related Commands
DescriptionCommand
Configures a switch profile.switch-profile
Cisco Nexus 5000 Series Interfaces Command Reference
86
R Commands
resync-database