errdisable recovery cause
To configure the application to bring the interface out of the error-disabled (err-disabled) state and retry
coming up, use the errdisable recovery cause command. To revert to the defaults, use the no form of this
command.
errdisable recovery cause {all| bpduguard| failed-port-state| link-flap-recovery| pause-rate-limit| udld}
no errdisable recovery cause {all| bpduguard| failed-port-state| link-flap-recovery| pause-rate-limit|
udld}
Syntax Description
Enables a timer to recover from all causes.all
Enables a timer to recover from bridge protocol data
unit (BPDU) Guard error disable state.
bpduguard
Enables a timer to recover from a Spanning Tree
Protocol (STP) set port state failure.
failed-port-state
Enables a timer to recover from linkstate flapping.link-flap
Enables a timer to recover from the pause rate limit
error disabled state.
pause-rate-limit
Enables a timer to recover from the Unidirectional
Link Detection (UDLD) error disabled state.
udld
Command Default
None
Command Modes
Global configuration mode
Command History
ModificationRelease
This command was introduced.4.2(1)N1(1)
Usage Guidelines
When error disable recovery is enabled, the interface automatically recovers from the err-disabled state, and
the device retries bringing the interface up.
Cisco Nexus 5000 Series Interfaces Command Reference
27
E Commands
errdisable recovery cause
To Next Page
Loading...
