interface mgmt
To enter the management interface configuration mode, use the interface mgmt command.
interface mgmt mgmt-intf-num
Syntax Description
Management interface number. The interface number
is 0.
mgmt-intf-num
Command Default
None
Command Modes
Global configuration mode
Command History
ModificationRelease
This command was introduced.4.0(0)N1(1a)
Examples
This example shows how to enter the management interface configuration mode:
switch# configure terminal
switch(config)# interface mgmt 0
switch(config-if)#
Related Commands
DescriptionCommand
Displays information about the management interface.show interface mgmt
Enables the Cisco Discovery Protocol (CDP) on an
interface.
cdp enable
Adds a description to an interface configuration.description (interface)
Configures the duplex mode for an interface.duplex
Enables the reception or transmission of Link Layer
Discovery Protocol (LLDP) packets on an interface.
lldp (interface)
Configures the packet per second (PPS) rate limit for
an interface.
rate-limit cpu direction
Cisco Nexus 5000 Series Interfaces Command Reference
51
I Commands
interface mgmt