Cisco Nexus 5000 Series - Show Port-Channel Summary

show port-channel summary
To display summary information about EtherChannels, use the show port-channel summary command.
show port-channel summary
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Global configuration mode
EXEC mode
Command History
ModificationRelease
This command was introduced.4.0(0)N1(1a)
Usage Guidelines
Before you use this command, you must configure an EtherChannel group using the interface port-channel
command.
Examples
This example shows how to display summary information about EtherChannels:
switch# show port-channel summary
Flags: D - Down P - Up in port-channel (members)
I - Individual H - Hot-standby (LACP only)
s - Suspended r - Module-removed
S - Switched R - Routed
U - Up (port-channel)
--------------------------------------------------------------------------------
Group Port- Type Protocol Member Ports
Channel
--------------------------------------------------------------------------------
1 Po1(SU) Eth LACP Eth1/1(P) Eth1/2(P) Eth1/3(P)
Eth1/4(P) Eth1/21(P) Eth1/22(P)
Eth1/23(P) Eth1/24(P) Eth1/25(P)
Eth1/26(P) Eth1/27(P) Eth1/28(P)
Eth1/29(P) Eth1/30(P) Eth1/31(P)
Eth1/32(P)
3 Po3(SU) Eth NONE Eth1/9(P) Eth1/10(P) Eth1/13(P)
Eth1/14(P) Eth1/40(P)
5 Po5(SU) Eth NONE Eth3/5(P) Eth3/6(P)
6 Po6(SU) Eth NONE Eth1/5(P) Eth1/6(P) Eth1/7(P)
Eth1/8(P)
12 Po12(SU) Eth NONE Eth3/3(P) Eth3/4(P)
15 Po15(SD) Eth NONE --
20 Po20(SU) Eth NONE Eth1/17(P) Eth1/18(P) Eth1/19(D)
Eth1/20(P)
24 Po24(SU) Eth LACP Eth105/1/27(P) Eth105/1/28(P) Eth105/1/29
(P)
Cisco Nexus 5000 Series Interfaces Command Reference
152
Show Commands
show port-channel summary