Cisco Nexus 5000 Series - Page 90

On a Cisco Nexus 5548UP switch, the 32 ports of the main slot (slot1) are unified ports. The Ethernet ports
start from port 1/1 to port 1/32. The FC ports start from port 1/32 backwards to port 1/1.
Examples
This example shows how to configure a unified port on a Cisco Nexus 5548UP switch or Cisco Nexus 5596UP
switch:
switch# configure terminal
switch(config)# slot 1
switch(config-slot)# port 32 type fc
switch(config-slot)# copy running-config startup-config
switch(config-slot)# reload
This example shows how to configure a unified port on a Cisco N55-M16UP expansion module:
switch# configure terminal
switch(config)# slot 2
switch(config-slot)# port 32 type fc
switch(config-slot)# copy running-config startup-config
switch(config-slot)# reload
This example shows how to configure 20 ports as Ethernet ports and 12 as FC ports:
switch# configure terminal
switch(config)# slot 1
switch(config-slot)# port 21-32 type fc
switch(config-slot)# copy running-config startup-config
switch(config-slot)# reload
Related Commands
DescriptionCommand
Enables preprovisioning of features or interfaces of
a module on a slot in a chassis.
slot
Reloads the switch and all attached Fabric Extender
chassis or a specific Fabric Extender.
reload
Cisco Nexus 5000 Series Interfaces Command Reference
80
P Commands
port