Cisco Nexus 5000 Series - Example Radius Configuration

Send feedback to nx5000-docfeedback@cisco.com
1-15
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring RADIUS
Example RADIUS Configuration
The following example shows how to display statistics:
switch# show radius-server statistics 10.10.1.1
Example RADIUS Configuration
The following example shows how to configure RADIUS:
radius-server key 7 "ToIkLhPpG"
radius-server host 10.10.1.1 key 7 "ShMoMhTl" authentication accounting
aaa group server radius RadServer
server 10.10.1.1
use-vrf management
Default Settings
Table 1-1 lists the default settings for RADIUS parameters.
Table 1-1 Default RADIUS Parameters
Parameters Default
Server roles Authentication and accounting
Dead timer interval 0 minutes
Retransmission count 1
Retransmission timer interval 5 seconds
Idle timer interval 0 minutes
Periodic server monitoring username test
Periodic server monitoring password test