Send feedback to nx5000-docfeedback@cisco.com
1-9
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring and Managing Zones
Zone Sets
In Figure 1-4, two separate sets are created, each with its own membership hierarchy and zone members.
Figure 1-4 Hierarchy of Zone Sets, Zones, and Zone Members
Zones provide a method for specifying access control, while zone sets are a grouping of zones to enforce
access control in the fabric. Either zone set A or zone set B can be activated (but not together).
Tip Zone sets are configured with the names of the member zones and the VSAN (if the zone set is in a
configured VSAN).
Activating a Zone Set
Changes to a zone set do not take effect in a full zone set until you activate it.
To activate or deactivate an existing zone set, perform this task:
Zone 3
H2, S2
Zone 2
H3, S2
Zone 1
H1, H3, S1
Zone set A Zone set B
H1 H2 H3
S1 S2
79537
Command Purpose
Step 1
switch# configuration terminal
switch(config)#
Enters configuration mode.
Step 2
switch(config)# zoneset activate name zoneset-name vsan
vsan-id
Activates the specified zone set.
switch(config)# no zoneset activate name zoneset-name
vsan vsan-id
Deactivates the specified zone set.
To Next Page
Loading...
