EasyManua.ls Logo

Cisco Nexus 5000 Series - Configuring the Dhchap Mode

Cisco Nexus 5000 Series
660 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Send feedback to nx5000-docfeedback@cisco.com
1-5
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring FC-SP and DHCHAP
DHCHAP
Table 1-1 identifies switch-to-switch authentication between two Cisco switches in various modes.
Configuring the DHCHAP Mode
To configure the DHCHAP mode for a particular interface, perform this task:
Table 1-1 DHCHAP Authentication Status Between Two MDS Switches
Switch N
DHCHAP
Modes
Switch 1 DHCHAP Modes
on auto-active auto-passive off
on
FC-SP
authentication is
performed.
FC-SP authentication
is performed.
FC-SP authentication
is performed.
Link is brought
down.
auto-Active FC-SP
authentication is
not performed.
auto-Passive
FC-SP authentication
is not performed.
off
Link is brought
down.
FC-SP authentication is not performed.
Command Purpose
Step 1
switch# configuration terminal
Enters configuration mode.
Step 2
switch(config)# interface fc
slot/port - slot/port
switch(config-if)#
Selects a range of interfaces and enters the interface
configuration mode.
Step 3
switch(config-if)# fcsp on
Sets the DHCHAP mode for the selected interfaces to be in the
on state.
switch(config-if)# no fcsp on
Reverts to the factory default of auto-passive for these three
interfaces.
Step 4
switch(config-if)# fcsp
auto-active 0
Changes the DHCHAP authentication mode for the selected
interfaces to auto-active. Zero (0) indicates that the port does
not perform reauthentication.
Note The reauthorization interval configuration is the same
as the default behavior.
switch(config-if)# fcsp
auto-active timeout-period
Changes the DHCHAP authentication mode to auto-active for
the selected interfaces. The timeout period value (in minutes)
sets how often reauthentication occurs after the initial
authentication.
switch(config-if)# fcsp
auto-active
Changes the DHCHAP authentication mode to auto-active for
the selected interfaces. Reauthentication is disabled (default).
Note The reauthorization interval configuration is the same
as setting it to zero (0).

Table of Contents

Other manuals for Cisco Nexus 5000 Series

Related product manuals