Cisco Nexus 5000 Series - Adding Show Commands to an Alert Group

Send feedback to nx5000-docfeedback@cisco.com
1-11
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring Smart Call Home
Configuring Call Home
This example shows how to associate all alert groups with the destination profile Noc101:
switch# configuration terminal
switch(config)# callhome
switch(config-callhome)# destination-profile Noc101 alert-group All
Adding show Commands to an Alert Group
To assign a maximum of five user-defined CLI show commands to an alert group, perform this task:
Note You cannot add user-defined CLI show commands to the CiscoTAC-1 destination profile.
Command Purpose
Step 1
switch# configuration terminal
Enters configuration mode.
Step 2
switch(config)# callhome
Enters callhome configuration mode.
Step 3
switch(config-callhome)#
destination-profile name alert-group
{All | Configuration |Diagnostic | EEM |
Cisco-TAC | Environmental | Inventory |
License | Linecard-Hardware |
Supervisor-Hardware | Syslog-group-port
| System | Crash | Test}
Associates an alert group with this destination profile.
Use the All keyword to associate all alert groups with
the destination profile.
Step 4
switch(config-callhome)# show callhome
destination-profile [profile name]
(Optional) Displays information about one or more
destination profiles.
Step 5
switch(config)# copy running-config
startup-config
(Optional) Saves this configuration change.
Command Purpose
Step 1
switch# configuration terminal
Enters configuration mode.
Step 2
switch(config)# callhome
Enters callhome configuration mode.
Step 3
switch(config-callhome)# alert-group
{Configuration | Diagnostic |
Environmental | Inventory | License |
Linecard-Hardware | Supervisor-Hardware
| Syslog-group-port | System | Test}
user-def-cmd show-cmd
Adds the show command output to any Call Home
messages sent for this alert group. You must enclose
the show command in double quotes. Only valid show
commands are accepted.