Cisco Nexus 5000 Series - Managing Cfs Regions; Assigning Applications to Cfs Regions

Send feedback to nx5000-docfeedback@cisco.com
1-11
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Using Cisco Fabric Services
CFS Regions
Managing CFS Regions
This section describes how to manage a CFS region. A set of commands are used to complete the
following tasks:
• Creating CFS Regions, page 1-11
• Assigning Applications to CFS Regions, page 1-11
• Moving an Application to a Different CFS Region, page 1-11
• Removing an Application from a Region, page 1-12
• Deleting CFS Regions, page 1-12
Creating CFS Regions
To create a CFS region, perform this task:
Assigning Applications to CFS Regions
To assign an application on a switch to a region, perform this task:
Moving an Application to a Different CFS Region
To move an application for example, from Region 1 (originating region) with NTP and Call Home
applications assigned to it, to Region 2 (target region), perform this task:
Note If you try adding an application to the same region more than once, you see the error message,
“Application already present in the same region.”
Command Purpose
Step 1
switch# configure
switch(config)#
Enters configuration mode.
Step 2
switch(config)# cfs region region-id
Creates a region.
Command Purpose
Step 1
switch# configure
switch(config)#
Enters configuration mode.
Step 2
switch(config)# cfs region region-id
Creates a region.
Step 3
switch(config-cfs-region)# ntp
switch(config-cfs-region)# callhome
Adds application(s).
Command Purpose
Step 1
switch# configure
switch(config)#
Enters configuration mode.
Step 2
switch(config)# cfs region region-id
Enters CFS region configuration submode.
Step 3
switch(config-cfs-region)# ntp
switch(config-cfs-region)# callhome
Indicates application(s) to be moved into Region 2
that originally belong to Region 1. For example, here,
the NTP and Call Home applications are moved to
Region 2.