Cisco Nexus 5000 Series - Displaying Flow Statistics

Send feedback to nx5000-docfeedback@cisco.com
1-16
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring Fibre Channel Routing Services and Protocols
Default Settings
switch# clear fcflow stats index 1
Displaying Flow Statistics
Use the show fcflow stats commands to view flow statistics. The following example displays the
aggregated flow summary:
switch# show fcflow stats aggregated
Idx VSAN frames
---------- ---------- ----------
6 1 42871
The following example displays the flow statistics:
switch# show fcflow stats
The following example displays flow index usage:
switch# show fcflow stats usage
2 flows configured
configured flow : 3,7
7
The following example shows how to display global FSPF information for a specific VSAN:
switch# show fspf vsan 1
The following example shows how to display a summary of the FSPF database for a specified VSAN. If
no additional parameters are specified, all LSRs in the database are displayed:
switch# show fspf database vsan 1
The following example shows how to display FSPF interface information:
switch# show fspf vsan 1 interface fc2/1
Default Settings
Table 1-2 lists the default settings for FSPF features.
Table 1-2 Default FSPF Settings
Parameters Default
FSPF Enabled on all E ports and TE ports.
SPF computation Dynamic.
SPF hold time 0.
Backbone region 0.
Acknowledgment interval (RxmtInterval) 5 seconds.
Refresh time (LSRefreshTime) 30 minutes.
Maximum age (MaxAge) 60 minutes.
Hello interval 20 seconds.
Dead interval 80 seconds.