Cisco Nexus 5000 Series - Displaying Vsan Trunking Information

Send feedback to nx5000-docfeedback@cisco.com
1-6
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring VSAN Trunking
Displaying VSAN Trunking Information
Figure 1-5 Operational and Allowed VSAN Configuration
Configuring an Allowed-Active List of VSANs
To configure an allowed-active list of VSANs for an interface, perform this task:
Displaying VSAN Trunking Information
The show interface command is invoked from the EXEC mode and displays VSAN trunking
configurations for a TE port. Without any arguments, this command displays the information for all of
the configured interfaces in the switch.
V
SANs 1 and 3 are on th
e
allowed
l
ist
.
V
S
A
Ns 1 and 3 are operatio
nal
.
V
SA
Ns
1
, 2, 5 are o
p
era
tion
al
.
V
SA
Ns
1,
2, 5 are o
n
the all
o
we
d
list.
VSANs 1 and 2 are operational.
VSANs 1 and 2 are on the allowed list.
Switch 3
VSAN1
VSAN2
VSAN4
VSAN5
Switch 1
VSAN1
VSAN2
VSAN3
VSAN4
VSAN5
Switch 2
VSAN1
VSAN2
VSAN3
79946
Command Purpose
Step 1
switch# configuration terminal
Enters configuration mode.
Step 2
switch(config)# interface fc slot/port
switch(config-if)#
Configures the specified interface.
Step 3
switch(config-if)# switchport trunk allowed vsan vsan-id
- vsan-id
Changes the allowed list for the
specified VSAN range.
switch(config-if)# switchport trunk allowed vsan add
vsan-id
updated trunking membership
Expands the specified VSAN to the
new allowed list.
switch(config-if)# no switchport trunk allowed vsan
vsan-id - vsan-id
Deletes the specified VSAN range.
switch(config-if)# no switchport trunk allowed vsan add
vsan-id
Deletes the expanded allowed list.