Send feedback to nx5000-docfeedback@cisco.com
1-17
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring Fibre Channel Interfaces
Default Settings
The following example shows the interface display when showing the running configuration for a
specific interface:
switch# show running configuration fc3/5
interface fc3/5
switchport speed 2000
switchport mode E
channel-group 11 force
no shutdown
Verifying BB_Credit Information
The following example shows how to display the BB_credit information for all Fibre Channel interfaces:
switch# show interface bbcredit
...
fc2/3 is trunking
Transmit B2B Credit is 255
Receive B2B Credit is 12
Receive B2B Credit performance buffers is 375
12 receive B2B credit remaining
255 transmit B2B credit remaining
Default Settings
Table 1-5 lists the default settings for native Fibre Channel interface parameters.
Table 1-5 lists the default settings for virtual Fibre Channel interface parameters.
Table 1-5 Default native Fibre Channel Interface Parameters
Parameters Default
Interface mode Auto
Interface speed Auto
Administrative state Shutdown (unless changed during initial setup)
Trunk mode On (unless changed during initial setup)
Trunk-allowed VSANs 1 to 4093
Interface VSAN Default VSAN (1)
Beacon mode Off (disabled)
EISL encapsulation Disabled
Data field size 2112 bytes
Table 1-6 Default Virtual Fibre Channel Interface Parameters
Parameters Default
Interface mode Auto
Interface speed n/a
To Next Page
Loading...
