Cisco Nexus 5000 Series - Page 625

Send feedback to nx5000-docfeedback@cisco.com
1-3
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring Fabric Configuration Servers
FCS Name Specification
Note Set this command globally only if every switch in the fabric belong to the Cisco MDS 9000 Family or
Cisco Nexus 5000 Series of switches.
To enable global checking of the platform name, perform this task:
To register platform attributes, perform this task:
Command Purpose
Step 1
switch# configuration terminal
switch(config)#
Enters configuration mode.
Step 2
switch(config)# fcs plat-check-global vsan
vsan-id
Enables global checking of the platform
name.
switch(config)# no fcs plat-check-global vsan
vsan-id
Disables (default) global checking of the
platform name.
Command Purpose
Step 1
switch# configuration terminal
switch(config)#
Enters configuration mode.
Step 2
switch(config)# fcs register
switch(config-fcs-register)#
Enters the FCS registration submode.
Step 3
switch(config-fcs-register)# platform name
SamplePlatform vsan vsan-id
switch(config-fcs-register-attrib)#
Enters the FCS registration attributes submode.
switch(config-fcs-register)# no platform name
SamplePlatform vsan vsan-id
switch(config-fcs-register)#
Deletes a registered platform.
Step 4
switch(config-fcs-register-attrib)# mgmt-addr
1.1.1.1
Configures the platform management IPv4
address.
switch(config-fcs-register-attrib)# no
mgmt-addr 1.1.1.1
Deletes the platform management IPv4
address.
switch(config-fcs-register-attrib)# mgmt-addr
2001:0DB8:800:200C::417A
Configures the platform management IPv6
address.
switch(config-fcs-register-attrib)# no
mgmt-addr 2001:0DB8:800:200C::417A
Deletes the platform management IPv6
address.
Step 5
switch(config-fcs-register-attrib)# nwwn
11:22:33:44:55:66:77:88
Configures the platform node name.
switch(config-fcs-register-attrib)# no nwwn
11:22:33:44:55:66:77:88
Deletes the platform node name.
Step 6
switch(config-fcs-register-attrib)# type 5
Configures the fc-gs-3 defined platform type.
switch(config-fcs-register-attrib)# no type 5
Deletes the configured type and reverts the
switch to its factory default of unknown type.
Step 7
switch(config-fcs-register-attrib)# exit
Exits the FCS registration attributes submode.
Step 8
switch(config-fcs-register)# exit
switch(config)#
Exits the FCS registration submode.