Send feedback to nx5000-docfeedback@cisco.com
1-9
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Troubleshooting
show tech-support Command
Tip You can save the output of this command to a file by appending > (left arrow) and the filename to the
show tech-support command. If you save this file, verify you have sufficient space to do so—each of
these files may take about 1.8 MB. However, you can zip this file using the gzip filename command.
Copy the zipped file to the required location using the copy command and unzip the file using the gunzip
command.
The default output of the show tech-support command includes the output of the following commands:
• show switchname
• show system uptime
• show interface mgmt0
• show interface mgmt1
• show system resources
• show version
• dir bootflash:
• show inventory
• show diagnostic result all
• show logging log
• show module
• show environment
• show sprom backplane
• show clock
• show callhome
• show cfs application
• show cfs lock
• show snmp
• show interface brief
• show interface
• show running-config
• show startup-config
• show ip route
• show arp
• show monitor session all
• show accounting log
• show process
• show process cpu
• show process log
• show process memory
• show processes log details
To Next Page
Loading...
