Cisco Nexus 5000 Series - Page 94

Send feedback to nx5000-docfeedback@cisco.com
1-10
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring Ethernet Interfaces
Displaying Interface Information
0 babble
0 Rx pause 8031547972 Tx pause 0 reset
The following example shows how to display the physical Ethernet capabilities:
switch# show interface ethernet 1/3 capabilities
Ethernet1/1
Model: AGD11342302
Type: 10Gbase-SR
Speed: 1000,10000
Duplex: full
Trunk encap. type: 802.1Q
Channel: no
Broadcast suppression: percentage(0-100)
Flowcontrol: rx-(off/on),tx-(off/on)
Rate mode: none
QOS scheduling: rx-(6q1t),tx-(1p6q0t)
CoS rewrite: no
ToS rewrite: no
SPAN: yes
UDLD: yes
Link Debounce: yes
Link Debounce Time: yes
MDIX: no
The following example shows how to display the physical Ethernet transceiver:
switch# show interface ethernet 1/3 transceiver
Ethernet1/3
sfp is present
name is CISCO-AVAGO
part number is SFBR-7700SDZ B4 R
revision is B4 R
serial number is AGD1134229V 070823
nominal bitrate is 0 MBits/sec
Link length supported for 50/125mm fiber is 0 m(s)
Link length supported for 62.5/125mm fiber is 0 m(s)
cisco id is --
cisco extended id number is 4
The following example shows how to display a brief interface status (some of the output has been
removed for brevity):
switch# show interface brief
--------------------------------------------------------------------------------
Ethernet VLAN Type Mode Status Reason Speed Port
Interface Ch #
--------------------------------------------------------------------------------
Eth1/1 200 eth trunk up none 10G(D) --
Eth1/2 1 eth trunk up none 10G(D) --
Eth1/3 300 eth access down SFP not inserted 10G(D) --
Eth1/4 300 eth access down SFP not inserted 10G(D) --
Eth1/5 300 eth access down Link not connected 1000(D) --
Eth1/6 20 eth access down Link not connected 10G(D) --
Eth1/7 300 eth access down SFP not inserted 10G(D) --
...
The following example shows how to display the link debounce status (some of the output has been
removed for brevity):
switch# show interface debounce
--------------------------------------------------------------------------------