6
Cisco Small Business NSS300 Series Smart Storage Administration Guide 249
Troubleshooting Abnormal RAID Operation
This chapter describes steps to troubleshoot abnormal RAID operation of your
Cisco NAS.
NOTE If the NAS administration interface cannot be accessed due to an improperly
configured port trunking mode, improperly configured Jumbo Frame setting, or an
incompatible switch, reset the network settings by pressing the reset button on the
back panel of the NAS for 3 seconds.
Before You Begin the Troubleshooting Process
CAUTION Before troubleshooting the RAID configuration of your NAS, back up the important
data on the NAS to avoid any potential data loss.
CAUTION Insert or remove only one drive from the NAS at a time.
CAUTION After inserting or removing a hard drive, wait until you hear two beeps from the NAS
before inserting or removing the next hard drive.
To Next Page
Loading...
Need help?
General
