Smartports
Built-in Smartport Macros
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 121
9
Smartport Application of the interface is Auto Smartport. Enabling Persistent
at an interface eliminates the device detection delay that otherwise will
occur.
• Macro Parameters—This block displays the parameter values of the
Smartport macro applied or to be applied to the interface.
• Reset—If an interface is in Unknown status (as a result of an unsuccessful
macro application), set it to Default and reapply the last macro that was run
on it.
STEP 4 Click Apply to update the changes and assign the Smartport type to the interface.
Built-in Smartport Macros
The following describes the pair of built-in macros for each Smartport type. For
each Smartport type there is a macro to configure the interface and an anti macro
to remove the configuration.
Macro code for the following Smartport types are provided:
• desktop
• printer
• guest
• server
• host
• ip_camera
• ip_phone
• ip_phone_desktop
• switch
• router
• ap
To Next Page
Loading...
Need help?
General
