UNITY INSTALLATION GUIDE
156
Natural
MicroSystems AG-T1
Continued
voice board
g The value you specify in the Protocol list depends on the
type of phone system you are connecting the Unity server to.
h In the ISA section, in the Address list, click the I/O address
that matches the DIP switch setting for this board. For a list
of settings, see “To set the I/O address DIP switch,” on
page 155.
i Click “OK” to close the Configure Board dialog box. The NMS
Configurator dialog box reappears.
j To add more boards, repeat steps c through i for each
board.
k Click “OK” to close the NMS Configurator dialog box.
l Return to the procedure that you were doing when the NMS
Configurator dialog box appeared.
Phone system Protocol list value
Mitel SX-2000 Digital/Analog Wink-Start
NEC NEAX 2400 Digital Loop-Start (OPS-FX)
To Next Page
Loading...
