APPPENDIX A:
Voice and fax boards
159
l Click “OK” to close the Configure Board dialog box. The NMS
Configurator dialog box reappears.
m If more than one AG Dual T1 board is installed, select the
next board in the list of boards, and repeat steps c
through l for each board.
n If the Unity server also contains AG-T1 boards, do the proce-
dure “To enter AG-T1 settings during Unity Setup,” on
page 155.
Otherwise, click “OK” to close the NMS Configurator dialog
box, and return to the procedure that you were doing when
the NMS Configurator dialog box appeared.
To Next Page
Loading...
